Call us
Water Heating Specials Conditions:
Some of the items below may be required for your specific installation and therefore maybe included in the quote provided after the site visit. Nothing below is included in the costs advertised on the Individual water heating specials page.
Quotes and Site Visits:
- All quotes and site visits are free of charge if the quote is accepted or if we cannot carry out the job at the advertised cost or estimated cost (Including the additional cost of any applying conditions below). If the quotation is higher than the due to unforeseen circumstances found on the site visit there is no charge for not proceeding with the work.
- If we make a site visit and can carry out the work as per the advertised or estimated cost there could be our minimum charge of $120+g.s.t (West Auckland) or $200+g.s.t (Outside West Auckland) if you choose not to proceed with the work. Note: This is just to cover some of our cost.
General:
Prices advertised are for West Auckland installs only, additional travel charges will apply outside West Auckland. This will be included in the quote. Please note: We do not cover all areas of Auckland.
Supply and installation of a safe or drain tray for any H.W.C replacements. This cost starts at $300+g.s.t if it is possible to run a drain pipe from cylinder position and cost depends on difficulty/length of running the drain pipe. Note: This will be included in the quote as a recommendation if it is possible for your installation.
Mains Pressure Installations: (Upgrading from low pressure only)
Converting more than 1 bathroom tapware from low to mains pressure. ($100+g.s.t each bathroom)
- Converting Standard Old style Felton Mix showers that require a rotar replacement. (+$70+g.s.t)
- Converting shower mixers that need to be removed from the wall to alter the pressure. ($25+g.s.t/15mins + Parts)
- Repair / Replacement of any tapware/piping due to hot water pressure increase. Additional charges may apply if a problem occurs after the pressure has been upgraded (This is not a common occurrence).
Gas Water Heater Replacements:
- Altering or changing any existing non-compliant work or positioning (Additional charges may apply of $25+g.s.t/15mins + material).
- Installing a pressure limiting valve on the cold supply pipe. If the water pressure is above 500kpa we would recommend installation ofa pressure limiting valve. ($250+g.s.t) We can check the pressure on site and advise if this is recommended.
Any Electrical Work Required: (Cost indications)
- Standard disconnect/reconnect to existing compliant circuit, no material needed. $120+g.s.t.
- Disconnect/Reconnect + Upgrade of the switch and wiring loom. $250+g.s.t.
- Wiring for a H.W.C in a new position or connecting a new power supply for an instant gas water heater. $350-$600+g.s.t. (We can arrange an electrician for this work on a charge-up basis + 15% margin, or you are welcome to arrange your own electrician for this work).